Elproblem

[livewire]

short out the pins to the trigger contacts and see if it fires, that'll let you know if its the signal cable to start off with, also what mosfet is it

[Knallhatt86]

I tried it, did not work, at least not every time, i got it to fire 1 in 100...
I measured the connectorcable with trigger pulled with a multimeter and it made contact.
It feels more and more like a burnt out mosfet. It is a Gate NanoAAB.

[livewire]

Sounds like it's shagged mate, but it can be a problem that the soldering can loosen occasionally on the boards, you could check out all the joints are whole and not loose, if theyre loose you can try to resolder or use a technique called reflowing, using a heat source, like a heat gun (värmluftspistol) where you melt the solder enough for it to remake contact, or just by a new one if you cant be arsed to go through all that

[Knallhatt86]

I think I will order a new one, and do some parallell testing with the busted one. :/

[Knallhatt86]

Tänkte bara uppdatera, mosfeten hade fått äta bajs, fixade en ny och nu går den fint igen!