Om någon missat att man enkelt själv kan modda burst el. FA

[Exocet]

Perhaps some of you know this, but maybe not. I figured I'd pass on this little trick to all the Systema PTW owners out there.

All PTW's can be either full auto or burst. They all have the capability to do both, regardless of which way you bought it.

If you have a burst gun and want full auto, or have an auto gun and want burst, just do this:

The main circuit board in the gun, EL-001, which is the longer one of the two sitting just forward of the gearbox, has three marked dual-solder points on it: P1, P2 and P3.

P1 is the key here.

If the two P1 solder joints are soldered together, you have burst.

If the two P1 solder joints are separate, you have full auto.

So, if you bought an auto gun and want burst, solder P1 together. If you have burst and want auto, use solder wick or a solder-sucker to seperate the P1 connection.

Enjoy!

P.S. If you have good soldering skills, an even better way to do the mod, and be able to switch between both modes is one of two ways:

1) solder a PC motherboard jumper and jumper pin socket onto P1. remove jumper for auto. put jumper on for burst. Nice!

2) solder two thin wires to each of the P1 connections and connect to a small toggle switch which you locate either in the lower receiver below the stock tube and above the handgrip, or in the stock tube itself. Flip switch to switch between modes.




Lättast att löda (och antagligen tänkt så..) på baksidan av kortet.

[Gwlyddyn]

Notera att det inte behövs lödning på 08:ans kretskort. Det enda som behövs är en bygel över två stift.

Byglat: Safe - Semi - Burst
Öppet: Safe - Semi - FA

[KrözaMajaHippie]

Finns det nån möjlighet och middag burst istället för semi så så man har burst och auto?
Mvh kröza

[Exocet]

Tror inte det, inte med standardkrets iaf.